Water is one of the most common ways a Florida house gets damaged from the outside, and the ground next to the foundation decides where that water goes. A home inspector walks the lot, the sides of the house and the low spots for one reason: to see whether rain will run away from the building or toward it. This guide explains what the Florida Building Code requires for lot grading and drainage, what an inspector typically notices, and what a buyer should do with the answer.
What the code requires for grade next to the house
The Florida Building Code, Residential, covers drainage in section R401.3. The text, as printed by the International Code Council and as quoted by county governments that review lot grading plans, has three parts:
- Surface drainage must be diverted to a storm sewer or another approved point of collection that does not create a hazard.
- Lots must be graded to drain surface water away from the foundation walls. The grade must fall at least 6 inches within the first 10 feet.
- Impervious surfaces, such as concrete or paving, within 10 feet of the foundation must slope at least 2 percent away from the building.
Six inches of fall over 10 feet is a 5 percent slope, which is easy to picture: the ground at the 10-foot mark sits half a foot lower than the ground at the wall. The 2 percent rule for paving is gentler, but it still means water on a driveway or patio should not pool against the house.
The code also gives one exception. Where lot lines, walls, slopes or other physical barriers prevent 6 inches of fall within 10 feet, drains or swales must be built to carry the water away from the structure. Osceola County’s lot grading procedure applies the same text to the grading plans it reviews, so the rule is used in practice, not only on paper.
The code applies to the work permitted under the code in force at the time. An older house may not meet today’s numbers. That does not make the grade acceptable. It means the inspector should describe what is there, explain how it affects the home, and let the buyer decide what to fix.
What an inspector looks at around the house
A standard home inspection is visual. The inspector walks the perimeter and notes conditions that point to water moving toward the building. The most common findings are:
- Soil or mulch piled against the siding, stucco or block. A wall that is buried in dirt stays wet longer and is harder to inspect. Our stucco moisture guide shows the warning signs on that wall type.
- Downspouts that discharge at the foundation. A gutter system can be working well and still send the roof’s water to the one place it should not go if the downspout ends at the wall or in a bed beside it.
- Paving pitched toward the house. Driveways, walks, patios and lanai slabs that fall toward the wall send water to the foundation. Look for dried silt lines or staining at the base of the wall after a storm.
- Sprinkler heads aimed at the building. Irrigation that wets the wall every day has the same effect as a leaking gutter.
- Low spots and standing water. A flat area beside the house, or a swale that has been filled in, holds water. A dry day can hide this, so the inspector looks for stains and settled sediment.
- Cracks and settlement near the foundation. Movement can change the grade over time. If the inspector sees cracking with uneven ground, the report should recommend a closer look. For sinkhole-type ground movement, see our sinkhole warning signs guide.
Neighbors matter too. A fence, wall or raised lot next door can block the flow across a shared line, and water from a higher lot can run onto yours. The inspector can only see the water when it reaches your property, so ask about the neighbor’s lot if the house sits low.
What a home inspection cannot tell you
A visual inspection has limits. It does not measure elevations to the code tolerance, and it does not see underground pipes, French drains or retention ponds. Three items need other documents:
- A survey. A survey shows lot lines, easements and the recorded grades on some properties. It is the document to check for a drainage easement that runs through the yard.
- An elevation certificate. This is the document that records a building’s elevation for flood insurance. A home inspection does not set the flood zone or the elevation. Our elevation certificate guide explains when a buyer should ask for one.
- Permit records. Drainage, grading and drain work often needs a permit. Check the building department’s records for past work. Our open permits guide shows how to check for unfinished work.
What a buyer should do with the findings
- Ask the seller in writing whether the yard has ponded after heavy rain, whether water has ever entered the home, and whether any drainage or grading work was done and by whom.
- Read the survey for drainage easements, lot elevations and any notes about grade.
- Get a repair quote before closing if the inspector flags a wet wall or a grade that slopes toward the house. The inspector describes the problem and does not do the repair. Depending on the fix, a licensed landscape or grading contractor, or a civil engineer for a larger problem, may be the right person.
- Read the insurance side. Flood premiums are set by flood risk, and a water problem at the house does not change the flood zone. Our guide to flood premiums and elevation certificates explains what insurers look at.
Drainage problems are often cheap to fix when they are found early and expensive when water has been getting into the wall for years. That is why the inspector’s note on grade belongs in the first read of the report, not the last.
Frequently asked questions
Does a Florida home inspection check the grade around the house?
Yes. The inspector looks at the ground, the paving and the drainage next to the foundation, and reports what is visible. A standard inspection does not survey the lot or measure elevations. If you need measured numbers, order a survey or an elevation certificate.
Is a flat yard a code violation?
For new work, R401.3 requires a 6-inch fall within the first 10 feet, unless an exception applies. For an older house, the answer depends on the code in force when the house was permitted. A home inspector reports the condition and the risk. A building official decides what is enforceable.
Can I fix the grade myself?
Some work is ordinary homeowner maintenance, such as moving soil away from the wall, adding splash blocks or extending a downspout. Work that changes swales, drains or the lot elevation may need a permit. Check with your local building department before you dig.
Will a drainage problem change my flood insurance?
Flood premiums are based on the building’s flood risk and its elevation, not on the yard alone. A surface-water problem can still matter for a claim, so keep the inspection report and any repair receipts. For how elevation and rating affect premiums, see the insurance guide linked above.
This article is general information, not legal advice or a code interpretation. Codes change and local building departments may apply them differently. Confirm the current requirements for a specific property with the local building department before you act.
Tariq AbouAdma, Certified Master Inspector, Florida license HI9899 Β· HUD 203(k) Consultant A1331
Quality Real Estate Inspections LLC Β· 336 Wilshire Blvd, Suite 274-229, Casselberry, FL 32707 Β· 321-222-3116
